Wpa enterprise validating identity consumating dating site

There's no WPA2 on the card, just WPA and WPA-PSK: WPA-PSK was the only setting that would let me enter a network key.I had TKIP and AES as options there, but cipher type is AES on the router, so I chose that.(I tried TKIP later, when this didn't work, with the same results as described below.) So I set it to WPA-PSK / AES and entered my security key.

And if I try again and return to the settings again, it is reset to Open/AES.It also re-enables 802.1x in the Authentication tab if I've deselected it with WPA-PSK. I have no idea how I blundered into getting this working in the past. Yes -- I think that's covered in the first image up top, which is a screenshot of my router settings.I am, as you can tell, far from proficient at this. It's 2.4GHz, WPA2-Personal/AES, and I'm not sure about regular or wide, but in "Mode" it says it takes 802.11n, 802.11g, and 802.11b. This is probably not the enterprsie setup which you have at home.Use this procedure to configure a Protected Extensible Authentication Protocol-Transport Layer Security (PEAP-TLS) wireless profile for wireless computers running Windows XP and Windows Server 2003.Membership in Domain Admins , or equivalent, is the minimum required to complete this procedure.

I'm currently doing a spare-parts build to put a media computer in the living room, and having a devil of a time getting my Rosewill RNX-6300 wireless card to connect to my network.

I'm trying to set it up using Windows as opposed to the proprietary Rosewill software -- the Rosewill software is a little over my head.

It can find the network fine, but when I try to connect, I don't get the password prompt -- it moves straight to "validating identity," scans, and then says "Windows was not able to find a certificate to log you on to the wireless network Foo." The maddening thing is that the card was working fine a week ago, in the same box, using the same OS.

I pulled everything out, swapped out the motherboard, and reinstalled Windows on a freshly wiped hard drive, and now I can't get it up and running again. I've taken several runs at it, including attempting to manually change the settings for the network to include WPA-PSK and AES and the password, and I'm a bit worried that I've totally boned everything.

My router settings: ipconfig/all results from the XP box: Again, this card a week ago.

I can't figure out why I can't get it up and running now.